![]() If necessary, you can follow the steps from the following Knowledge Base entry to assign specific MIDI Note Numbers to each pad With this setup, you'll be able to select the SPD-30 as the "MIDI device" within your software. Connect the USB cable to the computer, and then cycle the power on the SPD-30 (Off/On). The new settings are saved automatically.Ħ. Turn knob 1 to select "USB Driver," and then turn knob 3 to choose "VENDOR."ĥ. Press the function 2 button to choose the MIDI tab.Ĥ. Turn the function 1 knob to highlight "SYSTEM," and then press the function 3 button (ENTER).ģ. ![]() Once the drivers have been installed, be sure to set the SPD-30's USB driver mode to "VENDOR." Here's how:Ģ. Generally, it's not required to install the SPD-30 USB drivers, however if you experience problems, downloading and installing the SPD-30 USB drivers would be recommended. It's preferred to connect directly to a physical port on the computer, and not to a USB hub. This port can be used for transmitting/receiving MIDI Note Number data, velocity messages, CC messages and PC messages, and is convenient for triggering sounds and/or sequencing in the computer without having to use a separate external USB > MIDI Interface.įor setup, use a standard (A-B) USB cable and connect the USB "MIDI" port on the back of the SPD-30 to an available USB port on your computer. The SPD-30 has a Computer USB MIDI port for connecting directly to the computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |